MAC10 Performance Update.
Posted by ~Ray @ 2008-06-13 06:07:17
Not to be confused the MAC 10 sports a plastic body on the final product. There has been a small error in the previous news update stating the gun is full-metal which is incorrect.
The be of the gun uses the same ‘blast finished’ coating which is open on the Tokyo Marui’s new series of GBB Pistols and AEP SMGs. The silencer included in the gun has a brush aside rubber coating for the change surface feel.
The gun is set at a 45 degree go in the box to conform to the silencer magazine charger battery and other small parts. Roughly the MAC10 as stated from PDI’s homepage "it is about the coat as a WA MINI UZI."
The gun’s hop up is a dial write system which is accessible from the gun’s ejection port by simply pulling down on the bolt. This picture shows the MAC10 upper receiver removed to show the hop up dial which located behind the barrel. What has been done differently is the inner lay is a short lay that cannot be visible from the muzzle and has a nickel plate coating instead of the usual brass colored lay. This is to ensure the realism in Tokyo Marui’s new SMG. The move is also designed to lock when turned in a 90 degree action to prevent the ejection port from opening.
Also in news and pictures from Chameleon Japan. () and Military Blog ()
Pictured above is Chameleon’s own custom LIBRA Weapon bag. It is desire wrap-around holster that uses a fine fasten layer that does not appear loud when you rip the velcro off. It is designed to hold any SMGs and pistols and is strapped on to your Molle vest or web belt. Product information can be found here:
Comparison between the Tokyo Marui MP7A1 with the Tokyo Marui MAC10 side by side. Not noticeably large however the MAC 10 does have just as much to offer as the MP7A1.
This is a video made by Chameleon as he shows over the features of the gun. Disclaimer: Video is in Japanese! Nihongo wakarimasen!
Also to add. PDI JAPAN X-FIRE has listed a performance chart comparing the have inner barrel vs. PDI’s 01 barrel. Currently the MP7A1 barrel is used to evaluate however later they will test with a longer inner barrel designed with the suppressor.
Velocity Test Mac10 (normal) / 0.2gBB（Marui）/ Indoor Average 250.95 ft/sec 、76.51 m/sec、0.59J Mac10 (01 inner lay/135mm STD size)/ 0.2gBB（Marui）/ Indoor Average 259.65 ft/sec 、79.16 m/sec、0.63J Mac10 (01 inner lay/242mm Long size)/ 0.2gBB（Marui）/ Indoor Average 268.40 ft/sec 、81.83 m/sec、0.67J[ADVERTHERE]Related article:
http://arniesairsoft.co.uk/news2/2173
0 Comments:
No comments have been posted yet!
|
